Skip to main content
vanagon.com
SearchSavedAccount
← vanagon.com home · Continue the discussion in the forum
Subject:Re: Still need help/ball and socket joint end of throttle cable
From:Ian Cameron
Date:Mon, 28 Jun 1999 11:40:11 -0700

At 10:28 PM 6/27/99 -0400, Judith Barr/Leo Girard wrote:
>Hi all
>This must be either an insoluble problem or one so elementary that no one
>has deigned to help out.
>At the rear end of the accelerator cable installation (85 automatic) there
>is a snap on (ball & socket) union. It seems to me that this was engineered
>to be the fail safe/easy-to-replace part of the job. But the old cap WON'T
>come off the ball. Special tool needed? Special instructions? Anyone had
>trouble removing this critter before?
>The old cable snapped just at the join. There is about 1/2" tailpiece left
>on the cap. The cap swivels easily on the ball. The replacement has a small
>ring inside which (if the original is identical) wouldn't give enough
>resistance to upward 90� pressure not to release unless there is some
>element I'm not understanding.
>Help!!
>Leo
>Meaford ON
>
These can be a pig.  Douse with penetrant. Get a tiny open end wrench that
will fit over the cable but is smaller than the ball.  Place it against the
ball.  grip the cable with a vice grip.  Place a screw driver between vice
grip and wrench and pry.  The new one will go on more easily.