Skip to main content
vanagon.com
SearchSavedAccount
← vanagon.com home · Continue the discussion in the forum
Subject:temp guage read-out
From:Richards, Andrew
Date:Tue, 24 Jun 2008 12:21:03 -0700

List,

 

In the last 25K miles, I've replaced my radiator, water pump, thermostat, and just last night, my temp sensor that sends the signal to the dash.  I did the sensor in hopes of getting my dash gauge to sit in the middle over the flashing bulb, but it's still at � when at running temp.  Is there any way to get the needle to the middle??  It just seems so illogical.  

 

Also, I was told by a couple list members that the system is self-bleeding and I wouldn't have to bleed it after changing my temp sensor.  Well, I'm not seeing any change in the coolant levels of my expansion tank(s) after losing at least a few cups in the process of swapping sensors.  What's up with that?  Just to be sure, I'm going to go for a drive tonight with the heat all the way on and see what happens.

 

Thanks,

 

Andrew

'87 GL