Skip to main content
vanagon.com
SearchSavedAccount
← vanagon.com home · Continue the discussion in the forum
Subject:Re: Will the bolts hold the center seat?
From:George Goff
Date:Mon, 14 Nov 2005 01:55:42 EST

In a message dated 11/14/05 12:23:47 AM, paquette@NETHERE.COM writes:

<< It's been recommended to make spacers to put in the rails that it normally
slides into, then use grade 8 bolts to attach the seat on top of the rails. >>

Raymond,

I made spacers (standoffs, really) about an inch thick and 2 inches in
diameter from aluminum bar stock to place under the rails at the original anchor
points.  I punched holes in the floor covering (I also installed rubber matting)
to fit the standoffs then attached the rails on top of them with longer
fasteners.  With the rails well above the sound deadening material and the floor
covering, the seat slides in and out in without the hassle of lifting the carpet
and the sound deadening material.  One other thing I did was to install filler
strips cut from spare sound deadening material to fill the voids where the
seat rails had been.

George

George