Skip to main content
vanagon.com
SearchSavedAccount
← vanagon.com home · Continue the discussion in the forum
Subject:Re: Sealant necessary for coolant hoses?
From:M. Jade
Date:Fri, 25 Feb 2011 00:52:08 -0800

David, thanks a lot for the advice and I know what you are talking about. I already had an incident that the little hose from the top of the intake manifold to the plastic air bleeder suddenly went off when I was in the middle of a freeway at night. The� coolant waning light started to blink rapidly and I really had no time to think. Luckily I was able to pull over off a ramp within 100 yards and came to a safe spot in the city of Oakland California at night. Believe me it is not a city you will want to camp at night there. People are murdered on a weekly basis there.

I managed to make an emergency repair successfully just short of using some duct tape. I emptied all my spring water bottles to fill up the coolant reservoir and restarted the engine. There was apparently no damage whatsoever and I was able to reach home shortly.

Well, the van is so old. There are really too many aging parts to worry about. There is no way I can go over every one of them and replace them. I will have to depend on my gut feeling to determine what needs to be replaced before any others. I am in the middle of trouble shooting the coolant leak issue. If I decide to reseal the heads I will take a serious look at coolant and fuel hoses. They are all old...

MJ in sunny California

--- On Thu, 2/24/11, David Beierl <dbeierl@ATTGLOBAL.NET> wrote:

From: David Beierl <dbeierl@ATTGLOBAL.NET>
Subject: Re: Sealant necessary for coolant hoses?
To: vanagon@GERRY.VANAGON.COM
Date: Thursday, February 24, 2011, 9:34 AM

At 02:32 AM 2/24/2011, M. Jade wrote:
>Thanks a lot for everyone's quick reply to the question. The coolant
>hose is original. It was never replaced despite the thermostat has
>been replaced twice and the hose was disconnected and reconnected
>many times. I noticed that the hose is not as flexible as when it
>was very new. But it is not hardened to a point to need replacement.

You're talking about a twenty six year old hose here that's been
subjected to innumerable pressure/heat cycles.� VW hoses are of very
high quality but they do have their limits, and the limits I've
observed (n of approximately ten) have all but one involved a roughly
3/8" long slit in the longitudinal direction of an old but apparently
healthy hose.� No loss of flexibility apparent in any case.� In the
anomalous case the hose (still flexible) split transversely at the
nipple.� It was shortened a half inch and one week later split
again.� This was the odd hose on the 2.1l that has a skinny end going
to the ring manifold surrounding the engine hatch and a very short
fat right-angled end going to the engine.� The failure was at the engine.

My point is that these hoses are way past their intended service
lives, no matter what they look like.� I'm sensitive to this, since
the '89 I got a couple years ago had four coolant blowouts in the
first four months of driving, all in hoses that looked and felt perfectly good.

Yours,
David