Skip to main content
vanagon.com
SearchSavedAccount
← vanagon.com home · Continue the discussion in the forum
Subject:Re: 2.1 Conversion-Trouble Bleeding Cooling System
From:John
Date:Fri, 1 Dec 2006 18:47:09 GMT

Bob, I'm  a little confused, is this with the van raised on ramps?  Also, don't you need to open the front bleeder screw afterward? I'm still having bleeder problems.  I got it all bled, but then later my temp gage stopped working (again) and I am suspicious that air is trapped near the rear bleeder.  I did get air out of there once, raising the rear of the van, but now it seems that I can't get any coolant out the rear bleeder no matter what I do. John    >>>>Without opening the bleeders and the engine cold start the van. Rev the
engine this drives the coolant to the radiator top off the coolant and rev
the engine a little more to see if the level drops more add more coolant if
needed. Put the pressure cap on before you lower the engine RPM and you are
DONE