Skip to main content
vanagon.com
SearchSavedAccount
← vanagon.com home · Continue the discussion in the forum
Subject:Re: Dual Mass Flywheels and I5 dimensions needed.
From:Ron Cunningham
Date:Mon, 10 Jan 2005 16:16:39 -0400

I get:

1. 1.7 mm block to start of teeth, teeth width 10.3 mm
2. flywheel diameter 288 mm
3. block to throwout bearing contact surface 82 mm

RonC

-----Original Message-----
1    On the I5 motors, what is the distance from the block straight out to
where starter teeth on the flywheel begins?
2    What is the diameter of the I5 flywheel?
3    What is the distance form the block to the "flat" area where you would
push on the clutch fingers with the throw out bearing?