Skip to main content
vanagon.com
SearchSavedAccount
← vanagon.com home · Continue the discussion in the forum
Subject:timing does not advance
From:Chad Morris
Date:Wed, 3 Sep 2003 23:08:49 -0600

Hi all,

I followed procedures outlined in a posting by Mark Keller to set the timing on my '89 Carat, automatic.  According to his instructions I set the timing so that the mark on the pulley (which is supposed to be the 5 degrees BTDC mark) lines up with the case seam while the engine runs at 2400 RPM.  No problem there.  However, as I understand his instructions, above 3000 RPM, the timing should reach a total advance of 40 degrees.  On my engine the timing does not advance at all.  No matter where I set the timing at idle, at higher RPMs the timing does not change at all.  Can anyone explain this?

Chad Morris
89 Carat
Salt Lake City, UT