Skip to main content
vanagon.com
SearchSavedAccount
← vanagon.com home · Continue the discussion in the forum
Subject:Re: Leak at oil pressure switch
From:George Goff
Date:Sun, 13 Jul 2003 08:01:58 EDT

In a message dated 7/11/03 3:35:22 PM, reddi7@COMCAST.NET writes:

<< Is there any way to tighten the oil pressure switch (on rear of engine) on
a '87 Vanagon 2.1 without pulling the engine? >>

Richard,

I use a skeletal socket I made from a 15/16" deep socket.  I would have used
a 24 mm deep socket had I had one kicking around the toolbox when I entered
into battle with the well shrouded oil pressure switch.  I took a big bite out
of the middle of the socket which allowed limited although sufficient swing to
loosen the pressure switch.

George