Skip to main content
vanagon.com
SearchSavedAccount
← vanagon.com home · Continue the discussion in the forum
Subject:stripped flywheel bolt
From:Karl Wolz
Date:Wed, 1 Mar 2000 21:11:35 -0700

When I went to remove my flywheel today, I found that all of the hex bolts
had been rounded a bit by the engine's previous owner.  I managed to get
four of them out with no real problems (just hammered the wrench into the
bolt head).  The last one was, and now is more of, a mess.  I had applied
WD-40, tapped it with a hammer, and applied heat.  Any suggestions on what
to do now?   I'm planning on drilling it out tomorrow.

Thanks,

Karl Wolz